Servicing the 6kW Proven on Scoraig

I

levering the yaw bearing into position to fit new rollers.

Bookmark the permalink.

1 Response to I

  1. Terry Dury says:

    I grease the bolts and rubber ends every service this stops the wear, and look at the distance is equal
    all around the shaft, I have had my turbine for 9 years now and the same rubbers with no problem,
    I service my turbine every year grease the bearings and clean the contacts where the brushes rotate,
    insure the correct type of zip ties are used I use .9mm by .510mm and that gives you plenty of strength
    to hold the covers on, and never had any problems with them blowing off, all is well important to service
    every 12 months to the date weather permitting.

Leave a Reply

Your email address will not be published. Required fields are marked *