Lifting handle for the magnet rotor

I never like lifting magnet rotors into the mould.  The rotor for the 4F is very heavy, having 20 big ferrite magnets on a 50 cm disk. So I made a handle to lift it.  I had to make two of the holes in the mould base a bit big to accommodate the nuts on the ends of the handle studs.  Worked really nicely and not hard to do!

About hugh

I live off-grid in NW Scotland and have spent my life playing with wind turbines. I also love small hydros. Hands on renewable energy is my thing and I like to learn and to share my experiences.
This entry was posted in construction, ferrite magnets, my own projects. Bookmark the permalink.

3 Responses to Lifting handle for the magnet rotor

  1. thanks for sharing you project

  2. Arthur Sheridan says:

    are they three inch by two inch magnets you are using

    • admin says:

      hi

      Yes these are 75 x 50 mm which is about 3″ x 2″ for the 4 metre diameter turbine.

      cheers,
      Hugh

Leave a Reply to baju koko pria Cancel reply

Your email address will not be published. Required fields are marked *